The oiler is full of oil and are the size of a fat pen. A
Small amount of oil gets applied to anything that has friction after the old oil
is cleaned off. This is enough clock oil to do many clock movements. This is
enough oil to do about 15 clocks!
Included in Kit
Clock
Hand or Gear Puller
This is used to pull gears or hands off clocks in a straight and
safe fashion. With 400 day clocks in particular, the hour hand sometimes is
difficult to get off. Doing it by hand could increase the hour hand holes
diameter and the hand will not fit back on correctly because it would be
touching the dial. Using this simple tool prevents this from happening.
Included in Kit
Clock Level
The level is needed to be sure the clock stays in beat from
one place to another. Learn to set the clock in beat by the directions in the
E-book, making sure the clock is level when it is being done. Then keep a level
with the clock and where ever the clock goes, as long as its level, it will be
in beat. By being in beat, it means to have an even tick-tock-tick-tock rather
than ticktock---ticktock---ticktock. Often many repairs ONLY need to be set in
beat to work - however a cleaning is usually suggested anyhow.
Included in Kit
Please select your order below.
Weight driven kit includes everything but the below tool, spring driven will
include everything on this page, including the below tool.
NOTE: Spring driven clocks would need the below tool
Mainspring
Bench Key
This is a wooden tool that will go over your key in a
spring driven clock and allow you to release the power of the mainsprings. If
the power of the mainsprings are not released in a spring driven clock during
the cleaning process then they risk breaking and damaging the clock movement. It
is also a tool that is needed to disassemble any spring driven movement.
Included in Spring Driven Kit