Add the movements to the cart, then come back and choose hands from below
Movements come with various post lengths, this is the brass threaded portion of the movement that the hex nut goes on.
For the correct post length, measure the thickness of the dial (face) of the clock
Instruction Video

- Included hardware and hanger.
- Hands are free
- 3 Year Warranty
- Threaded Shaft Diameter 5/16"
- 2 1/8 x 2 1/8 x 5/8
- Select quality / post length below
FOR PENDULUM UNITS
CLICK HERE
Instruction Video

Dial (clock face) Thickness
- 1/8 inch thick
- 1/4 inch thick
- 3/8 inch thick
- 1/2 inch thick
- 3/4 inch thick
Size Post Needed
- 3/16"
- 5/16"
- 7/16"
- 11/16"
- 15/16"
For the correct post length, measure the thickness of the dial (face) of the clock.
Then use the chart and see what post length you need.
The post length is only the brass threaded portion.
Instruction Video
Chinese Step Motion
Item #M1
Low price movements that are common in clocks made in mass production. Second hand will jump from one second to the next if used.
Hands are free if you select them, otherwise none will be sent. (See Below)
1+ $10 / 6+ $8 / 12+ $6 Item #M1
USA Step Motion
#M2
The most common movement for schools and hobbyists to produce clocks. With this movement the second hand will jump from one second to the next.
Hands are free if you select them, otherwise none will be sent. (See Below)
1+ $12 / 6+ $10 / 12+ $8 Item #M2
Japanese Step Motion
#M3
Exceptional quality produced by Seiko, this movement is very durable and reliable. Second hand will jump from one second to the next (if used)
Hands are free if you select them, otherwise none will be sent. (See Below)
1+ $14 / 6+ $12 / 12+ $10 Item #M3
High Torque Continuous
#M7
You will not hear a ticking sound and the second hand sweeps around with no jumping, if used. This is also a high torque movement that will run long or short hands.
Hands up to 5" are free if you select them, otherwise none will be sent. (See Below)
1+ $23 / 6+ $20 / 12+ $18 Item #M7
USA High Torque
#HTM1
This movement runs short hands, or very long hands that can
be purchased on this page.
Some sizes available in C cell
Hands up to 5" are free if you select them, otherwise none will be sent. (See Below)
1+ $16 / 6+ $14 / 12+ $12 Item #HTM1
Japanese High Torque
#HTM2
This unit can run below hands, also run hands up to 18 inches in length. Long hands can be purchased separately from this page
Hands up to 5" are free if you select them, otherwise none will be sent. (See Below)
1+ $20 / 6+ $18 / 12+ $16 Item #HTM2
Minute hand measured from the hole to tip.
Hour hand that comes with the set is smaller proportionally
Item# - H1
Item# - H2
Item# - H3
Item# - H4
Item# - H5
Item# - H6
Item# - H7
Item# - H8
Item# - H9
Item# - H10
Item# - H11
Minute hand measured from the hole to tip.
Hour hand that comes with the set is smaller proportionally
Measured from the center of the post to the end
Item# - SH1
Item# - SH2
Item# - SH3
Item# - SH4