Cuckoo Help

launch

question_answer 0 Questions/Answers

View more

turned_in_notCuckoo Help

The lift wires travel from the movement up to the flaps of the old bellow tops. Furthermore, these wires are taken off in order to remove the cuckoo bellows. Usually this is done by opening the loop on the lower end of the lift wire. This is where it connects to the movement’s lift arm. Use a small flat head… View Product

launch

question_answer 1 Questions/Answers

View more

turned_in_notCuckoo Help

A new cuckoo clock movement will be a fraction of the price of an overhaul on the old one. This is due to the time it takes to separate the plates, work on the movement, and then put it all back together again. This process is very time consuming. Then, if the movement fails the testing process, it all has… View Product

launch

question_answer 0 Questions/Answers

View more

turned_in_notCuckoo Help

The most common Cuckoo repair parts sold is the bellow tops and the hands. The bellow tubes are usually good to reuse on the clock, just the bellow tops have cloth that rip over time and therefore the clock will not cuckoo the time out. If the cloth is ripped the entire cuckoo bellows do not need to be replaced…. View Product

launch

question_answer 0 Questions/Answers

View more

turned_in_notCuckoo Help

When the new cuckoo clock movement will not go into striking mode for the hours. The bird will not come out and the clock will not indicate what time it is with the cuckoo call. Here are some guidelines on what to check in this situation. There is a wire above the cuckoo door that locks it into the closed… View Product

launch

question_answer 5 Questions/Answers

View more

turned_in_notCuckoo Help

Installing the cuckoo clock hands bought from clockworks.com starts with removing the old hands. To remove the cuckoo hands will only need a pair of needle nose pliers. While holding the minute hand still (longer of the two hands) while loosening the minute hand nut with the pliers. Turning the hand nut in the counter clockwise direction while holding the… View Product

launch

question_answer 0 Questions/Answers

View more

turned_in_notCuckoo Help

Issues with the strike quantity on a cuckoo clock is a common ailment upon setting up a new movement. The clock will strike 12 o’clock and then 12 again at 1 o’clock or something like this. This has to do with the mechanical components behind the clock dial. Remove the hands and dial to get to that section of the… View Product

launch

question_answer 11 Questions/Answers

View more

turned_in_notCuckoo Help

Upon installation of a new cuckoo clock movement this is a common issue. The Cuckoo clock door stuck open could be a number of things. Please check the following to see if it solves the issue of the door not closing all the way. If the pine cone weight that controls the cuckoo portion of the clock is not heavy… View Product