Hands

launch

question_answer 0 Questions/Answers

View more

turned_in_notHands

The following are accessories that fit the quartz clock movements that Clockworks offers. There are many different types of quartz movements on the market, hence we specifically state these items are for the movements that we sell. Of course Clockworks encourages organizations to offer clock building as a fun project. Therefore, each product is available with bulk pricing for schools… View Product

launch

question_answer 0 Questions/Answers

View more

turned_in_notHands

High-Torque clock hands are any minute hand over 5 inches. Of course, they need a strong battery movement known as High Torque. To get the correct size, measure the minute hand only, from the center of the mounting hole to the tip. You will receive one set of hands, minute and hour, from that one measurement. The hands we sell… View Product

launch

question_answer 0 Questions/Answers

View more

turned_in_notHands

The installation of the clock hands on a German mechanical movement is reverse of removal. If either the movement was replaced, or the hands are new, the minute hand must be adjusted. This is so it will point to the correct time when it chimes. First comes the hour hand as a friction fit. Put the hand on its round… View Product

launch

question_answer 0 Questions/Answers

View more

turned_in_notHands

These are the directions to get a German mechanical clock to chime on time. This means having the clock hands point to the right spot when the clock chimes. When replacing a clock movement, or getting new clock hands, either one, you will notice it will chime 5 minutes before it is supposed to, or 10 min after, something like… View Product

launch

question_answer 0 Questions/Answers

View more

turned_in_notHands

The German mechanical clock hands are sold by the time track diameter. When ordering these mechanical clock hands, this measurement is important. To clarify, the dial diameter is the measurement of the time track. This means from just outside the 9 straight across to just outside the 3. For example, if this time track diameter is 6 inches, then select… View Product

launch

question_answer 2 Questions/Answers

View more

turned_in_notHands

Removing Mechanical Clock Hands is fast and easy to do. The following are hand removal instructions for German mechanical movements post WW2. Removing mechanical clock hands for post WW2, mantle and floor clocks is quite simple. Turn the hand nut to the left while holding the minute hand with fingers. Use some small needle nose pliers to loosen the nut… View Product