Hermle Mechanical Clock Movement Availability

July 17, 2019 6:31 am Published by Leave your thoughts

Hermle Mechanical Clock Movement Availability

Hermle Mechanical Clock Movement Availability is excellent. We stock all Hermle Clock Movements, with very few exceptions. Some special CM lengths may be a special order. If it's not on the charts we may still have it, just contact us. You can call or email a picture or the numbers to [email protected] If a CM option is not listed, we can still make it up special for you.

Who is Hermle?

Hermle is one of the largest movement producers in the world today. Not only do they have the most movements being made, but they also have the best part availability. This is good for when you need a component such as a pendulum or a dial, or a complete clock kit. A Hermle Clock Movement generally lasts 25 to as much as 40 years. We usually get calls to replace units that were built in the early 80's or late 70's.

Why get the new one?

Replacing these units rather than getting them cleaned and oiled is usually the smart way to go. It has been factory improved, brand new, factory lubricated, easy to install. The new one would cost the fraction of the price of an overhaul on the old unit. Keep in mind however, that there are different grades of the same movement number. Some are cheaper, but they contain plastic parts. The Hermle units that we offer here at Clockworks are the best grade available.

What numbers to get

The movement number has three or four numbers, then a dash, and some more numbers, then a CM length underneath it if there is a pendulum. They are all consistent as they always have the numbers, then a dash, then more numbers. Basically if there is a dash in the movement number, and it's all numbers in the beginning with no letters like "A", it's a Hermle unit for sure. If there is an A before the number then it can still be a Hermle, but with the Seth Thomas name and numbering system.

What the numbers mean

On the back plate of the clock movement you will see the numbers such as 451-050 94cm. These numbers let us know everything we need to know about the mechanical clock movement itself. This tells us if the clock is weight driven or spring driven, if it has a pendulum, the size of the movement and the length of the hand shaft and much more. To match up the numbers to the new movement numbers is to get the exact same movement you have now but brand new. Since the new movement will be the exact same and not some knock off imitation, all of your existing clock components will usually fit just the same as the old unit.

- - The content of this web page and web site was written and copyright by James Stoudenmire of Clockworks.com - It may not be used commercially without permission. - -

Leave a Reply