Select Arabic or Roman Numerals, White or Ivory. Measurements are from outside the numeral on one side to outside the numeral on the other side. (The timetrack diameter)
This steeple dial is pointed on the top of it. It comes in two sizes and you can punch it to fit a spring movement or use it for a quartz movement. The overall measurements are listed below
Set of three dial key hole grommets. These are what make the key holes pretty where you wind the clock through the dial.
Item #CP32 - $2.
Ten piece clock dial assortment made of heavy paper stock and plastic. Sized dials from 4 inch to 11 inch assorted. These dials can be glued to a wooden back board and used for many quartz clock projects.
Item #RD14 $7
Convex round clock glass gets measured from one side to the other, the overall width. Please take into account that the glass has to be wider than the opening in the bezel, but not so big that it is too wide for the glass tabs to lock it into place.
Round Convex - Item BZ1
Flat round clock glass gets measured from one side to the other, the overal width. Please take into account that the glass has to be wider than the opening in the bezel, but not so big that it is too wide for the glass tabs to lock it into place.
Round flat - Item # BZ2
There are two basic types of clock dials available. There are dials that are not specific for any one clock, and than there are the dials that are for one particular mechanical movement series. When the dial is not for any particular movement, it will have the center hole for the hand shaft drilled only and the dial will have no feet posts on the back. These can be used or adapted for any style clock mechanical or battery.
The glass has to fit into the bezel and has to be perfect, not too small so it falls out of the bezel and not so big it will not fit into the bezel clips. So to get the proper size glass, measure exactly how wide you would like the glass so it will not be too big for the bezel clips and not so small it falls out the front.