Clock-Movement Calendar Removal Instructions

Posted on    Posted in  turned_in_not  Repair Help

Clock-Movement Calendar Removal

This section is referring to the Clock-Movement Calendar Removal Instructions for calendar versions of the Hermle clock movement 141-040 141-030 and 141-033

Many of these units come with a calendar as indicated by the letter K after the movement numbers. This is the usual way some movements are supplied by the manufacturer. This way it covers movements with and without a calendar.

In this way only one style is to be made, shipped, and stored ready to ship. So sometimes the new movement only comes into the country with a calendar attached. The below information will enable the removal of the calendar portion if needed to do so for the installation.

Such as if the calendar tube is in the way of installing the new movement to the dial.

Clock-Movement Calendar Removal Instructions Continued

Look at the new movement and see two hex nuts on the front of the clock holding a small plate with gears under it. See that the old unit does not have this.

Take these hex nuts off, and the plate, and slide the big gear off of the hand shaft. This big gear is just for the calendar.

There is a small C clip that blocks the hour hand tube from coming off. Remove the C clip with a small flat screwdriver and the hour hand tube will come off. Do the same thing with the old unit and put the old unit hour hand tube on the new unit.

Note the exact position of the new movement’s hour tube. This position is important to note before taking it off and put the old unit’s hour tube in the exact position. What is meant by position is the humps on the snail looking portion that is attached to the hour hand tube.

This has to be the same position on the new one just like it was on the old. If it is not the same then the hourly strikes will be off. The deepest slot is 12 o’clock and the highest hump is 1 o’clock.

Post Removal

The mounting posts where the hex nuts were located are still on the clock movement. Now if these are in the way of mounting the movement to the dial, they would need to be removed. The clock movement calendar removal would require these to be snapped off.

This may seem harsh but if using a pair of pliers and bend them down and up, they will snap off. This is because these posts are only pressed in by machine and there is no other way to remove them. This is the intent of the factory to have done, when needed.

Strike Count Reset

It is time to test the strikes and see if they are correct and that the hour hand tube in the correct position. Make the clock strike and count how many times it strikes.

If one o’clock and 12 o’clock strike correct its all set. Tf it strikes 1 and 12 out with the correct number of strikes, then the rest is ok also.

If this is too much information then send in the old unit and the new unit and we will swap it out at for a charge of $30 Plus shipping.

The content of this website is copyright by Clockworks and written by James Stoudenmire in year 2022

↑ Back to top
Tags: 

0
Ask a Clock Question

Subscribe
Notify of
guest

0 Comments
Inline Feedbacks
View all comments

Shop By Brand

Shop Hermle

Find the perfect Hermle movement for your clock.

Howard Miller

Find the perfect Howard Miller movement for your clock.

Shop Kieninger

Find the perfect Kieninger movement for your clock.

Seth Thomas

Find the perfect Seth Thomas movement for your clock.

Shop Urgos

Find the perfect Urgos movement for your clock.

Ridgeway Clocks

Find the perfect Ridgeway movement for your clock.

Our Associations

time.gov

clockify.me

nawcc.org

bhi.co.uk

awci.com