Cuckoo repair parts

July 21, 2019 9:37 am Published by Leave your thoughts

Cuckoo repair parts

The most common Cuckoo repair parts sold is the bellow tops and the hands. The bellow tubes are usually good to reuse on the clock, just the bellow tops have cloth that rip over time and therefore the clock will not cuckoo the time out.

So if this is the situation you do not need the entire cuckoo bellows as in CU1, you only need the tops as seen on CU4. If just replacing the tops it makes it a lot easier to get the correct size for your clock as the CU1 comes in only one size tops. To get the proper tops you only need to measure the length and width of the top only. You would snap off the old tops off of the bellow tubes and clean the surface with a knife, then epoxy the new tops on the same way, the same position. Then you would transfer the cuckoo lift rings from the old tops to the new ones and your done.

Cuckoo Clock Repair

Cuckoo Clock Repair

The help section can help with many of the most common issues the clock may have. We also have the cuckoo clock movements for post 1950 German made units. This is about 80 percent of the cuckoos out in the world so chances are we have the movement you need.

If the movement is worn out and is post 1950 its just as well to get the new one instead of overhauling the old one. The process of the movement overhaul is time consuming and therefore expensive, when the new movement is 100-200 dollars and will last alot longer than the best overhaul.

- - The content of this web page and web site was written and copyright by James Stoudenmire of Clockworks.com - It may not be used commercially without permission. - -

Ask a Clock Question

avatar